ISOFLAMM^®
cold-bonding self-adhesive membranes –

Bonding instead of torching

Special conditions call for special solutions. In some cases, traditional polymer-bitumen waterproofing membranes are not possible to apply, like polystyrene insulation, temperature-sensitive substructures or fire-sensitive areas where torching applications are prohibited.

The solution in such cases is to use self-adhesive polymer-bitumen waterproofing membranes – such as Slavonia’s ISOFLAMM^® cold-bonding self-adhesive membranes.

Cold-bonding self-adhesive polymer-bitumen waterproofing membranes usually provide the first waterproofing layer. They are mostly laid on heat-sensitive surfaces such as EPS (expanded polystyrene), vacuum heat insulation or PIR/PUR (polyurethane). They must be covered by a top layer membrane fully applied on it. Self-adhesive membranes are not necessary in the case of mineral wool insulation.

The choice of insulation material depends on several factors: fire protection regulations, available structure heights, the purpose and use of the roof, and the system construction of the building.

 

ISOFLAMM^® cold-bonding self-adhesive membranes – quality that lives up to its promise

The underside of the ISOFLAMM^® cold-bonding self-adhesive membranes is equipped with a high-quality cold-bonding self-adhesive compound and a peel-off sheet that is removed just before installation. The self-adhesive membrane achieves its full adhesive force when the next waterproofing layer is torched to the surface or insulation.

ISOFLAMM^® cold-bonding self-adhesive membranes:

ISOFLAMM^® KSU 3
ISOFLAMM^® KSU 4
ISOFLAMM^® KSU 4 wf

“wf” = “root-proof” (required for waterproofing green roofs)

Call us or write to us for detailed information about our ISOFLAMM^® cold-bonding self-adhesive membranes.